nRF7002 EK v1.0.0

Preparing the nRF7002 EK

To measure current, you must first prepare the Evaluation Kit (EK).

Figure 1. Preparing the EK for current measurements
Preparing the nRF7002 EK for current measurements

To measure current in the VBAT domain, put P6 in series with the load and cut solder bridge SB1. To restore normal EK function after measurement, apply a jumper on P6 or short solder bridge SB1.

Note: If you want to measure current in the VDD domain, you must change the connector and solder bridge used, see Components for current measurement on VDD and VBAT and Solder bridge configuration.