SiP 2DID %2DID
The proprietary %2DID command reads the 2DID of the nRF91x1SiP. The 2DID corresponds to the two-dimensional barcode etched on top of the module.v2.2.x
Modem trace activation %XMODEMTRACE
The proprietary %XMODEMTRACE command activates modem traces. The trace data is in binary format and can help the Nordic customer support to analyze and resolve issues.v2.2.x
Extra maximum TX power reduction %XEMPR
The proprietary %XEMPR command allows to configure an extra reduction of 0.5 or 1 dB to the maximum transmission power on all or selected supported 3GPP bands separately in the NB-IoT and LTE-M modes.v2.2.x
Antenna detection test %XANTDETMAGPIO
The proprietary %XANTDETMAGPIO command reads the MAGPIO pin status to detect if the antenna is connected. The antenna is detected when the pin is grounded to DC.v2.2.x
RX test %XRFTEST
The proprietary %XRFTEST command can be used to test the nRF91x1 receiver. The command enables the RF receiver and measures signal power at the SiP antenna port with a time domain power meter and returns the measurement result and headroom.v2.2.x
TX test %XRFTEST
The proprietary %XRFTEST command can be used to enable the RF transmitter. The command also measures TX power with an internal measurement receiver in the time domain and returns the measurement result.v2.2.x
AFC measurement and set %XRFTEST
The proprietary %XRFTEST command can be used to measure or set the AFC error value for a given frequency.v2.2.x
RF sensor test %XRFTEST
The proprietary %XRFTEST command allows reading the temperature sensor next to the PA inside the SiP and another temperature sensor inside the nRF9120 SoC.v2.2.x
File system sync to flash %XFSSYNC
The proprietary %XFSSYNC command synchronizes and stores AT command configurations to the modem’s non-volatile memory.v2.2.x