You can use the Nordic Thingy:53™
current measurement and debug board to measure certain currents on the Nordic Thingy:53.
The currents are the following:
- The current flowing to the nPM1100 Power Management Integrated Circuit (PMIC) from the battery through
the P1 connector
- The current flowing to the nRF5340 System on Chip (SoC) from the VOUTB rail
through the P2 connector
- The current flowing to the nRF21540 RF FEM from the VOUTB rail through the P3
connector
- The current flowing to external devices from the 3V3 regulator through the P4
connector
Load switches U4, U5, U11, and U14 are disengaged
when the Nordic Thingy:53 current measurement
and debug board is inserted into the debug board interface (P9).
The following schematic describes the load switches.