nRF52 DK interface

Connectors P1, P3, P4, P6, P7, and P8 are used to connect the DK add-on to the nRF52 DK.

Through these connectors, all the functionality of the DK add-on can be accessed by the nRF52 DK. See nRF52 DK interface connections for pin information.

Table 1. nRF52 DK interface connections
Pin Label Description Short
P1_1 VIO Voltage domain VIO  
P1_2 VIO Voltage domain VIO  
P1_3 NC Not connected  
P1_4 VIO Voltage domain VIO  
P1_5 V5V Voltage domain V5V  
P1_6 GND Ground  
P1_7 GND Ground  
P1_8 VIN Voltage domain VIN  
 
P3_1 TP SHDN TP voltage regulator on/off  
P3_2 A1 LD3 control SB1
P3_3 NC Not connected  
P3_4 NC Not connected  
P3_5 I2C CLK I2C clock SB2
P3_6 NC Not connected  
 
P4_1 NC Not connected SB33
P4_2 I2C CLK2 I2C 2 clock SB3
P4_3 MIC CLK Digital microphone clock  
P4_4 MIC DOUT Digital microphone data output  
P4_5 POWER ON/OFF Control signal power switch  
P4_6 D5 LD4 control SB4
P4_7 NC Not connected SB5
P4_8 NC Not connected SB6
 
P6_1 DISCHARGE Discharges the TP voltage regulator SB10
P6_2 ICM-20608 INT Motion tracking device interrupt SB9
P6_3 NC Connected to test point 2  
P6_4 IR LED Infrared LED control signal input  
P6_5 WU IRQ TP interrupt or I/O expander interrupt SB11
P6_6 LIS3DH INT1 Low-power accelerometer interrupt 1  
P6_7 GND Ground  
P6_8 I2C_DATA2 I2C 2 data SB12
P6_9 I2C_DATA I2C 1 data  
P6_10 I2C_CLK I2C 1 clock  
 
P7_1 NC Not connected  
P7_2 NC Not connected  
P7_3 NC Not connected  
P7_4 NC Not connected  
P7_5 NC Not connected  
P7_6 GND Ground  
 
P8_1 NC Not connected  
P8_2 NC Not connected  
P8_3 NC Not connected  
P8_4 NC Not connected  
P8_5 NC Not connected  
P8_6 NC Not connected  
P8_7 NC Not connected  
P8_8 NC Not connected