The nRF7002 DK is a hardware development platform to facilitate the
design and development of Wi-Fi® 6
applications.
The Development Kit (DK) combines the Wi-Fi 6 capabilities of the nRF7002 companion Integrated Circuit (IC) with the nRF5340
System on Chip (SoC).
Key features
- nRF7002 Wi-Fi companion IC
- Dual-band 2.4 GHz and 5 GHz Wi-Fi 6
- Compatible with IEEE 802.11ax (also known as Wi-Fi 6) and earlier standards IEEE
802.11a/b/g/n/ac.
- 20 MHz wide channels, 1x1 (SISO) operation and up to 86 MHz 802.11 PHY rate, QSPI
for fast host interface support
- Open-source Wi-Fi driver -
L2 Network Technologies layer-compatible
- 3 or 4-wire COEX interface configurations
- Secure, 64-word One Time Programmable (OTP) memory with logical and voltage-level
based protection mechanisms
- nRF5340
SoC, with support for the following additional wireless
protocols:
- Onboard 2.4 GHz and 2.4/5 GHz antennas
- NFC antenna
- An optional 32.768 kHz crystal (X2) for higher accuracy and lower average power
- Microwave coaxial connector with switch (SWF) RF connector for direct RF measurements
- User-programmable LEDs (2) and buttons (2)
- SEGGER J-Link on board programmer/debugger
- Pins for measuring power consumption
- 1.8 V power supply from Universal Serial Bus (USB) or external Lithium-polymer (Li-Poly) battery
- 3.6 V power supply from USB or external Li-Poly battery to the VBAT of the
nRF7002 companion IC
For access to firmware source code, hardware schematics, and layout files, see www.nordicsemi.com.
Note: The nRF7002 DK must be powered by a PS1 class
(IEC 62368-1) power supply with maximum power less than 15 W.
The
nRF7002 DK is intended for use only
by skilled persons.
A skilled person is someone with relevant education or experience that
enables them to identify potential hazards and takes appropriate action to reduce the risk
of injury to themselves and others.