nRF5340 Audio DK v1.0.0

Solder bridge overview

The nRF5340 Audio Development Kit (DK) has a range of solder bridges for enabling or disabling selected functionalities. Changes to the solder bridges are not needed for normal use of the DK.

The following table is a complete overview of the solder bridges on the nRF5340 Audio DK.
Table 1. Solder bridges
Designator Description Default state Layer
SB1 Short to connect digital microphone DOUT to P1.06 Open Top
SB2 Cut to disconnect P0.12 from TRACE Shorted Top
SB3 Short to connect PMIC MODE to VOUTB, must not be shorted while SB4 is shorted Open Top
SB4 Cut to disable PMIC MODE from GND, must not be shorted while SB3 is shorted Shorted Top
SB5 Cut to enable VBAT current measurements on P6 Shorted Top
SB6 Cut to enable HW CODEC 1.2V current measurements on P7 Shorted Top
SB7 Cut to enable HW CODEC 1.8V current measurements on P8 Shorted Top
SB8 Cut to enable VDD_nRF current measurements on P9 Shorted Top
SB9 Cut to disconnect filter from OUTP Shorted Top
SB10 Cut to disconnect filter from OUTN Shorted Top
SB11 Cut to disconnect the LED for the HW CODEC GPIO Shorted Top
SB12 Cut to disconnect digital microphone POWER from the HW CODEC Shorted Bottom
SB13 Cut to disconnect digital microphone DATA from the HW CODEC Shorted Bottom
SB14 Cut to disconnect digital microphone CLOCK from the HW CODEC Shorted Bottom
SB15 Short to connect AUX I2S MCLK to HW CODEC MCLK1 Open Top
SB16 Short to connect AUX I2S MCLK to HW CODEC MCLK2 Open Top
SB17 Short to connect P5 pin 6 to GND Open Top
SB18 Cut to disconnect P5 pin 6 from SHIELD DETECT Shorted Top
SB19 Cut to disconnect RTS and CTS flow control lines on UART1 Shorted Top
SB20 Cut to disconnect RTS and CTS flow control lines on UART2 Shorted Top
SB21 Cut to disconnect nRF53 RESET from RESET button when debug is disabled Shorted Top
SB22 Short to permanently connect RESET button to nRF53 RESET Open Top
SB23 Cut to disconnect RESET button from interface MCU Shorted Top
SB24 Short to bypass analog switch for MCLK Open Top