The Power Profiler Kit II (PPK2) is operated in Source Meter mode for this
configuration.
-
Connect the PPK2 to the nPM1300
Evaluation Kit (EK) with the 4-pin measurement cable using the
following pins:
- PPK2
GND to nPM1300 EK
GND on P1 (pin 5)
- PPK2
VOUT to nPM1300 EK
VBAT on P1 (pin 3)
-
Make sure a jumper is connected between VBATIN and
VBAT on P1 (pins 1 and 2).
-
Connect the load (nRF5340 Development Kit (DK) in this example) to
VOUT1 (pin 1 or 2) and GND (pin 3 or 4) on
nPM1300 EK
P4.
-
Connect the PPK2 to a computer using a USB
cable.
-
Start the Power Profiler app.
-
Select your PPK2.
-
Select Source Meter as the mode.
-
Set the supply voltage to value between 2.3 V to 4.45 V.
-
Toggle Enable power output to power the nPM1300 EK.
-
Click Start.