The set command writes the %XMIPIRFFEDEV configuration to nRF91x1 RAM
memory.
Syntax:
%XMIPIRFFEDEV=<dev_id>,<def_usid>,<prod_id>,<man_id>,<pm_trig>
The
set command parameters and their defined values are the following:
- <dev_id>
- Selectable identification number for the device. Non-zero. Valid range 1–255. The
given <dev_id> is used with the %XMIPIRFFECTRL and
%XMIPIRFFEDBG commands.
- <def_usid>
- A 4-bit default Unique Slave Identifier (USID) for the MIPI RF Front-End Control Interface (RFFE) device. Typically, 7 for antenna tuners (as suggested by
MIPI).
- <prod_id>
- An 8-bit PRODUCT_ID of the MIPI RFFE device. Only used if automatic reprogramming of
the USID is needed. EXT_PRODUCT_ID is not supported.
- <man_id>
- A 10-bit MANUFACTURER_ID of the MIPI RFFE device. Only used if automatic reprogramming
of the USID is needed.
- <pm_trig>
- An 8-bit content for PM_TRIG (address 0x1C = 28 dec) register. This is for setting the
default power and triggering mode. The setting of PM_TRIG can be also changed in the ON
phase. See %XMIPIRFFECTRL.
All numbers should be given as decimals, that is, not as hexadecimals. Currently,
nRF91x1 supports
only one System in Package (SiP)-external MIPI RFFE-controlled
device.