%XANTDETMAGPIO set command

The set command changes the pin specified in the command to input mode and sets internal pull-up for the corresponding pin.

After this, the pin state is read and reported in the command response.

Syntax:

%XANTDETMAGPIO=<magpio_pin>

The set command parameter and its defined values are the following:

<magpio_pin>: 0, 1, 2 – The MAGPIO pin whose state is read.

The response values are the following:

1 – Antenna connected
0 – Antenna not connected

After the command, the pin state is set back to normal (high-Z).

The following command example sets MAGPIO pin 2 to input mode and sets internal pull-up for it. After this, the pin state is read and reported in the command response. After the command, the pin state is set back to normal (high impedance state):

AT%XANTDETMAGPIO=2
%XANTDETMAGPIO: 0
OK

Set command