Set command

The set command sets the extra reduction to maximum TX power.

The command can be given separately to the Narrowband Internet of Things (NB-IoT) and LTE-M modes. If a band is not mentioned in the command, the EMPR is 0 for that band. The command cannot be used to increase transmission power. %XEMPR should be given before the activation of the modem to be effective. If a valid EMPR configuration exists, the reduction is automatically applied to the applicable transmissions.





The set command parameters and their defined values are the following:

0 – NB-IoT
1 – LTE-M
The number of bands to which EMPR is set. If <k> is 0, the next parameter <pr_for_all_bands> is applied to all supported 3GPP bands. The %XEMPR command supports listing the power reduction for all the supported bands of nRF91x1 in one command for both NB-IoT and LTE-M.
The number of the 3GPP band to which the following <prn> is applied.
EMPR for <bandn>
0 – 0 dB
1 – Maximum power reduced 0.5 dB
2 – Maximum power reduced 1.0 dB
> 2 is not allowed

The following command example reduces the maximum TX power on all bands in the NB-IoT mode by 1 dB:


The following command example reduces the maximum TX power on three (<k>=3) bands in the LTE-M mode (<system_mode>=1). The maximum TX power is reduced by 1 dB on bands 5 and 8 and by 0.5 dB on band 13:


The following command example deletes the existing configuration by sending the command without any parameters: