Set command

The set command configures the modem to comply with the requirements of various mobile network operators.

The command configuration is stored to Non-volatile Memory (NVM) approximately every 48 hours and when the modem is set to minimum functionality mode with the +CFUN=0 command. The stored configuration is in use when the device is powered on.

Active %XPOFWARN warning blocks the storing to NVM.

Syntax:

%XOPCONF=<op_conf>

The set command parameter and its defined values are the following:

<op_conf>
Integer
1 – Automatically detected from International Mobile Subscriber Identity (IMSI)
2 – Verizon
3 – AT&T
4 – China Telecom
5 – Softbank
6 – Telstra
7 – Bell
8 – LG U+
9 – KDDI
10 – Truphone
11 – Telus Jasper V2
12 – Vodafone
13 – T-Mobile
14 – Deutsche Telekom
15 – Rogers
16 – Orange
17 – KT
18 – Telefonica

The following command example sets Verizon operator configuration:

AT%XOPCONF=2
OK