nRF91 AT commands: Network service related commands

PLMN selection +COPS
The +COPS command selects a PLMN automatically or manually, and reads and searches the current mobile network. v2.0.x

Forced PLMN search %COPS
The proprietary %COPS command performs a forced PLMN search. v2.0.x

Power saving mode setting +CPSMS
The +CPSMS command controls PSM settings. v2.0.x

eDRX setting +CEDRXS
The +CEDRXS command controls the setting of eDRX parameters. v2.0.x

EDRX dynamic parameters +CEDRXRDP
The +CEDRXRDP command reads dynamic eDRX parameters. v2.0.x

Operator name +COPN
The +COPN command reads operator names. v2.0.x

Network registration status notification +CEREG
The +CEREG command subscribes unsolicited network status notifications. v2.0.x

Operator name notification %XOPNAME
The proprietary %XOPNAME command subscribes unsolicited operator name notifications. v2.0.x

Network time notification %XTIME
The proprietary %XTIME command subscribes unsolicited network time notifications. v2.0.x

Operator ID %XOPERID
The proprietary %XOPERID command identifies the operator USIM. v2.0.x

Modem parameters %XMONITOR
The proprietary %XMONITOR command reads a set of modem parameters. v2.0.x

Network time support %XNETTIME
The proprietary %XNETTIME command controls if the time received from the network is used. v2.0.x

Weak cell detection %XDEEPSEARCH
The proprietary %XDEEPSEARCH command supports averaging cell search mode to detect weak cells. v2.0.x

Mobile network operator %XOPCONF
The proprietary %XOPCONF command configures the modem for the selected mobile network operator. v2.0.x

Release assistance indication %RAI
The proprietary %RAI command activates and deactivates RAI support for access stratum and control plane.v2.0.x

Periodic cell search configuration %PERIODICSEARCHCONF
The proprietary %PERIODICSEARCHCONF command is used to configure periodic cell searches in limited service state.v2.0.x

Reduced mobility feature configuration %REDMOB
The proprietary %REDMOB command is used to reduce LTE idle mode mobility, such as swapping between cells in stationary use cases. The command can be used according to the relaxed monitoring standard defined in 3GPP TS 36.304 Ch. 5.2.4.12 or in a Nordic-proprietary way. v2.0.x

Feature configuration %FEACONF
The proprietary %FEACONF command is used to set support for the configurable features of the modem. v2.0.x