%XOPCONF set command

The set command configures the modem to comply with the requirements of various mobile network operators. The configuration is stored in Non-volatile Memory (NVM) when the device is powered off with +CFUN=0. The stored configuration is in use when the device is powered on.

Syntax:

%XOPCONF=<op_conf>

The command parameter and its defined values are the following:

<op_conf>: 1 – Automatically detected from IMSI; 2 – Verizon; 3 – AT&T; 4 – China Telecom; 5 – Softbank; 6 – Telstra; 7 – Bell; 8 – LGU+

The example command sets Verizon operator configuration:

AT%XOPCONF=2
OK

Set command