Set command

The set command disables or enables the use of the final result code +CME ERROR.

Syntax:

<+CMEE=[<n>]>

The set command parameters and their defined values are the following:

<n>
0 – Disable and use ERROR instead (default)
1 – Enable +CME ERROR: <err> result code and use numeric <err> values. <err> values are specified in 3GPP TS 27.007 Ch. 9.2. Vendor-specific values listed in the command chapters, the value range starts from 512.

The following command example enables error codes in responses:

AT+CMEE=1
OK