Set command

The set command subscribes or unsubscribes unsolicited internal temperature notifications.

A notification is sent when the temperature is rising above a high or critical temperature level or cooling down from a critical or high temperature level.

Syntax:

%XTEMP=<n>

Notification syntax:

%XTEMP: <temperature_level>,<temperature>

The set command parameters and their defined values are the following:

<n>
0 – Subscribe unsolicited temperature indications
1 – Unsubscribe unsolicited temperature indications

The notification parameters and their defined values are the following:

<temperature_level>
1 – Normal temperature
2 – High temperature. Factory default 55. This can be changed with High level for internal temperature %XTEMPHIGHLVL.
3 – Critical temperature. TX/RX disabled. Factory default 90.
<temperature>
Integer. Celcius degrees between −40 and 125.

The following command example subscribes notifications:

AT%XTEMP=1
OK

The example shows an unsolicited notification for an internal temperature level:

%XTEMP: 1,37
%XTEMP: 2,56
%XTEMP: 3,91