nrf9160

Set command

The set command sets the CS/PS Mode of Operation. The +CEMODE command should be used only when the modem is not activated. The command configuration is stored to Non-volatile Memory (NVM) approximately every 48 hours and when the modem is set to minimum functionality mode with the +CFUN=0 command.

Active %XPOFWARN warning blocks the storing to NVM.v1.3.x≥2

Syntax:

+CEMODE=[<mode>]

The set command parameter and its defined values are the following:

<mode>
0 – PS mode 2 of operation
2 – CS/PS mode 2 of operation

The following command example sets the operating mode to PS mode 2:

AT+CEMODE=0
OK
Parent topic: Mode of operation (CS/PS) +CEMODE