New and inherited anomalies

The following anomalies are present in revision Engineering B of the nRF52840 chip.

Table 1. New and inherited anomalies
ID Module Description New in Engineering B Inherited from Engineering A nRF52840
20 RTC Register values are invalid   X
36 CLOCK Some registers are not reset when expected   X
55 I2S RXPTRUPD and TXPTRUPD events asserted after STOP   X
66 TEMP Linearity specification not met with default settings   X
78 TIMER High current consumption when using timer STOP task only   X
81 GPIO PIN_CNF is not retained when in debug interface mode   X
87 CPU Unexpected wake from System ON Idle when using FPU   X
94 USBD BUSSTATE register is not functional   X
122 QSPI QSPI uses current after being disabled   X
136 System Bits in RESETREAS are set when they should not be   X
153 RADIO RSSI parameter adjustment   X
155 GPIOTE IN event may occur more than once on input edge   X
166 USBD ISO double buffering not functional   X
170 I2S NRF_I2S->PSEL CONNECT fields are not readable   X
171 USB,USBD USB might not power up   X
173 GPIO Writes to LATCH register take several CPU cycles to take effect   X
174 SPIM SPIM3 events incorrectly connected to the PPI X  
176 System Flash erase through CTRL-AP fails due to watchdog time-out   X
179 RTC COMPARE event is generated twice from a single RTC compare match   X
183 PWM False SEQEND[0] and SEQEND[1] events   X
184 NVMC Erase or write operations from the external debugger fail when CPU is not halted   X
186 POWER High current consumption in System ON Idle, using High Voltage mode X  
187 USBD USB cannot be enabled X  
189 SPIM RX buffer error at 32 MHz operation X  
190 NFCT Event FIELDDETECTED may be generated too early X  
191 RADIO High packet error rate in BLE Long Range mode X  
192 CLOCK LFRC frequency offset after calibration   X
193 SPIM SPIM3 does not generate EVENTS_END and halts if suspended during last byte X  
194 I2S STOP task does not switch off all resources   X
195 SPIM SPIM3 continues to draw current after disable X  
196 I2S PSEL acquires GPIOs regardless of ENABLE   X
198 nRF52840 SPIM3 transmit data might be corrupted X  
201 CLOCK EVENTS_HFCLKSTARTED might be generated twice   X
202 POWER Device does not start up in high voltage mode X  
Parent topic: nRF52840 Engineering B Errata