New and inherited anomalies

Table 1. New and inherited anomalies
ID	Module	Description	New in Engineering A
20	RTC	Register values are invalid	X
36	CLOCK	Some registers are not reset when expected	X
55	I2S	RXPTRUPD and TXPTRUPD events asserted after STOP	X
66	TEMP	Linearity specification not met with default settings	X
78	TIMER	High current consumption when using timer STOP task only	X
87	CPU	Unexpected wake from System ON Idle when using FPU	X
136	System	Bits in RESETREAS are set when they should not be	X
170	I2S	NRF_I2S->PSEL CONNECT fields are not readable	X
173	GPIO	Writes to LATCH register take several CPU cycles to take effect	X
176	System	Flash erase through CTRL-AP fails due to watchdog time-out	X
183	PWM	False SEQEND[0] and SEQEND[1] events	X
184	NVMC	Erase or write operations from the external debugger fail when CPU is not halted	X
187	USBD	USB cannot be enabled	X
190	NFCT	Event FIELDDETECTED may be generated too early	X
194	I2S	STOP task does not switch off all resources	X
196	I2S	PSEL acquires GPIOs regardless of ENABLE	X
210	GPIO	Bits in GPIO LATCH register are incorrectly set to 1	X
212	SAADC	Events are not generated when switching from scan mode to no-scan mode with burst enabled	X
218	NFCT	Frame delay timing is too short after SLP_REQ	X
219	TWIM	I2C timing spec is violated at 400 kHz	X
223	USBD	Unexpected behavior after reset	X
225	RADIO	RSSI parameter adjustment	X
228	RADIO	No interrupt is generated for SYNC event	X
233	NVMC	NVMC READYNEXT not generated	X
236	RADIO	Conversion formulas for RADIO energy related values incorrect in PS	X
237	SAADC	TASKS_CALIBRATEOFFSET shall only be used before TASKS_START or after EVENTS_END	X
243	RADIO	T_IFS is inaccurate with Bluetooth Long Range	X
245	RADIO	CRC is wrong when data whitening is enabled and address field is included in CRC calculation	X
246	System	Intermittent extra current consumption when going to sleep	X
248	RADIO	Reading DTX in MODECNF0 gives incorrect value	X
251	NVMC	NVMC ERASEALL is blocked when access port protection is enabled	X
252	SAADC	Unexpected behavior when TASKS_CALIBRATEOFFSET is used during sampling	X
258	RADIO	PHYEND event is delayed for some AoA and AoD configurations	X

[20] RTC: Register values are invalid
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[36] CLOCK: Some registers are not reset when expected
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[55] I2S: RXPTRUPD and TXPTRUPD events asserted after STOP
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[66] TEMP: Linearity specification not met with default settings
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[78] TIMER: High current consumption when using timer STOP task only
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[87] CPU: Unexpected wake from System ON Idle when using FPU
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[136] System: Bits in RESETREAS are set when they should not be
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[170] I2S: NRF_I2S->PSEL CONNECT fields are not readable
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[173] GPIO: Writes to LATCH register take several CPU cycles to take effect
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[176] System: Flash erase through CTRL-AP fails due to watchdog time-out
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[183] PWM: False SEQEND[0] and SEQEND[1] events
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[184] NVMC: Erase or write operations from the external debugger fail when CPU is not halted
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[187] USBD: USB cannot be enabled
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[190] NFCT: Event FIELDDETECTED may be generated too early
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[194] I2S: STOP task does not switch off all resources
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[196] I2S: PSEL acquires GPIOs regardless of ENABLE
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[210] GPIO: Bits in GPIO LATCH register are incorrectly set to 1
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[212] SAADC: Events are not generated when switching from scan mode to no-scan mode with burst enabled
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[218] NFCT: Frame delay timing is too short after SLP_REQ
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[219] TWIM: I2C timing spec is violated at 400 kHz
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[223] USBD: Unexpected behavior after reset
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[225] RADIO: RSSI parameter adjustment
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[228] RADIO: No interrupt is generated for SYNC event
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[233] NVMC: NVMC READYNEXT not generated
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[236] RADIO: Conversion formulas for RADIO energy related values incorrect in PS
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[237] SAADC: TASKS_CALIBRATEOFFSET shall only be used before TASKS_START or after EVENTS_END
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[243] RADIO: T_IFS is inaccurate with Bluetooth Long Range
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[245] RADIO: CRC is wrong when data whitening is enabled and address field is included in CRC calculation
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[246] System: Intermittent extra current consumption when going to sleep
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[248] RADIO: Reading DTX in MODECNF0 gives incorrect value
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[251] NVMC: NVMC ERASEALL is blocked when access port protection is enabled
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[252] SAADC: Unexpected behavior when TASKS_CALIBRATEOFFSET is used during sampling
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.

[258] RADIO: PHYEND event is delayed for some AoA and AoD configurations
This anomaly applies to IC Rev. Engineering A, build codes QIAA-AB0, QDAA-AA0, CJAA-AB0.