Macros | |
| #define | NRF_CSENSE_ENABLED |
| Enable capacitive touch sensor module. More... | |
| #define | NRF_CSENSE_PAD_HYSTERESIS |
| Minimum value of change required to determine that a pad was touched. More... | |
| #define | NRF_CSENSE_PAD_DEVIATION |
| Minimum value measured on a pad required to take it into account while calculating the step. More... | |
| #define | NRF_CSENSE_MIN_PAD_VALUE |
| Minimum normalized value on a pad required to take its value into account. More... | |
| #define | NRF_CSENSE_MAX_PADS_NUMBER |
| Maximum number of pads used for one instance. More... | |
| #define | NRF_CSENSE_MAX_VALUE |
| Maximum normalized value obtained from measurement. More... | |
| #define | NRF_CSENSE_OUTPUT_PIN |
| Output pin used by the low-level module. More... | |
| #define NRF_CSENSE_ENABLED |
Enable capacitive touch sensor module.
Set to 1 to activate.
| #define NRF_CSENSE_MAX_PADS_NUMBER |
Maximum number of pads used for one instance.
| #define NRF_CSENSE_MAX_VALUE |
Maximum normalized value obtained from measurement.
| #define NRF_CSENSE_MIN_PAD_VALUE |
Minimum normalized value on a pad required to take its value into account.
| #define NRF_CSENSE_OUTPUT_PIN |
Output pin used by the low-level module.
This is used when capacitive sensor does not use COMP.
| #define NRF_CSENSE_PAD_DEVIATION |
Minimum value measured on a pad required to take it into account while calculating the step.
| #define NRF_CSENSE_PAD_HYSTERESIS |
Minimum value of change required to determine that a pad was touched.