[178] SAADC: END event firing too early

This anomaly applies to IC Rev. Rev 1, build codes QFAA-B00, QFAB-B00, CIAA-B00.

It was inherited from the previous IC revision Engineering C.


False END events.


Offset calibration is run with TACQ < 10 µs before sampling is started.


The END event can occur earlier than expected. Data is not ready.


Apply one of the following workarounds:
  • Run offset calibration with TACQ >=10 µs.
  • Apply STOP task after calibration, before sampling. CALIBRATEOFFSET -> CALIBRATEDONE -> STOP -> STOPPED -> START.