This Device Firmware Update (DFU) example illustrates how to create an application that can be updated over the mesh. It shows the general setup and how to handle the relevant events.
The mesh DFU supports two modes: side-by-side DFU and bootloader DFU. The side-by-side mode transfers the new firmware in the background while the application is running and reports to the application when the transfer is done. The application may then flash the new firmware when ready. In bootloader mode, the application is not running, and the bootloader takes care of the transfer. This mode is primarily meant as a fallback mechanism, in case the application malfunctions. This example application demonstrates the side-by-side mode DFU.
This DFU application requires a bootloader and a valid device page to function correctly. Precompiled bootloaders are included in the bin directory at the project root directory, and the device page must be generated with the device_page_generator.py script located in tools/dfu/device_page.py.
See the DFU quick start guide for detailed instructions on how to perform a DFU operation using this example application.